Start a conversation

Detection Zone Test

Devices → [DEVICE] → Settings → Detection Zone Test → Start

The detection area tests allow you to determine the distance at which the detector will detect alarms and protect it from false triggering. In test mode, the light indicator lights up continuously, switching off during the alarm. In order to determine the detection area, use the device light indication as a guide.

Device Procedure of testing
DoorProtect, DoorProtect Plus
In order to check the opening detector at the suggested installation place, open and close the door/window. If the detector responds to all actions, it is installed correctly.
MotionProtect, MotionProtect Plus
In order to check the motion detector, walk across the room, following the LED reaction, and determine the detector detection area.
The glass break detector registers an alarm if it detects two components: a low-frequency component (sound of impact against glass) and a high-frequency component (impacts of shards against each other).
Therefore, in order to check the glass break detector, bang the hard surface with your fist (preferably the glass plane, but without breaking it). The detector must respond to the low-frequency sound of the impact against the glass, turning off the LED for 0.2 s. If this happens, throw a metal object (for example, a spoon) at the hard surface or hit it with a glass tumbler within one and a half seconds. The detector will turn off the LED for a second; this means that in armed mode, the glass break detector will normally respond to the glass breaking. Decrease the detector sensitivity and keep checking until the detector stops responding to the alarm sounds. After this, bring the sensitivity level back to the previous limit at which the detector responded normally. In this way, the probability of the detector being falsely triggered is minimized and at the same time provides reliable protection for the facility. To provide maximum protection against false triggering, turn on all appliances that usually operate in the room: generators, air conditioners, etc. If switching on these devices intermittently causes the detector to activate, its installation place should be chosen more carefully.
Combine MotionProtect and GlassProtect testing.

If the detector responds poorly to the alarms during the tests, it is necessary to choose another location.

Choose files or drag and drop files